Internet of Things with Arduino Blueprints by Pradeeka Seneviratne

Author:Pradeeka Seneviratne [Seneviratne, Pradeeka]
Language: eng
Format: azw3
Publisher: Packt Publishing
Published: 2015-10-27T04:00:00+00:00

Solder additional wires to the connection pads are mentioned as:

Solder wire 5 (black) into the GND connector pad

Solder wire 6 (yellow) into the CVBS connector pad

Testing NTSC video stream with video screen

Use an RCA jack and solder two wires, as stated here:

Solder a yellow wire to the center terminal

Solder a black wire to the outer terminal

Then make the other connections as follows:

Connect the yellow wire to the RCA jack's signal terminal.

Connect the black wire to the RCA jack's ground terminal.

Now, connect the TTL serial camera to a regulated 5V power source, the red wire to positive, and the black wire to negative. You can use an Arduino board to get the regulated 5V power. Connect the red wire to Arduino 5V pin and the black wire to Arduino GND pin, and connect Arduino to the 9v power supply.

Finally, connect the soldered RCA jack to the NTSC monitor using an RCA video cable. If you are living in a region that does not support the NTSC broadcasting system, then you have to purchase a basic NTSC/PAL monitor. But some televisions support both NTSC and PAL broadcasting systems. Check your television's user manual for more information. If it does not support NTSC, then you have to purchase an NTSC- supported monitor from Adafruit (http://www.adafruit.com/product/946), or search eBay for a cheaper one.

Download

Copyright Disclaimer:
This site does not store any files on its server. We only index and link to content provided by other sites. Please contact the content providers to delete copyright contents if any and email us, we'll remove relevant links or contents immediately.